Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Establish Sessions on Port-Channels

To establish a session, you must enable BFD at interface level on both ends of the link, as shown in the following example. The session parameters do not need to match.

Figure 1. Establishing Sessions on Port-Channels Illustration of establishing sessions on port-channels.

To establish a session on a port-channel, use the bfd neighbor ip-address command in INTERFACE PORT-CHANNEL mode.

View the established sessions using the show bfd neighbors command, as shown in Changing Port-Channel Session Parameters .

Viewing Established Sessions for VLAN Neighbors 

R2(conf-if-po-1)#bfd neighbors 2.2.2.1
                                 R2(conf-if-po-1)#do show bfd neighors
                                 * - Active session role
                                 Ad Dn - Admin Down
                                 C - CLI
                                 I - ISIS
                                 O - OSPF
                                 R - Static Route (RTM)
                                 V - VRRP
                                 LocalAddr RemoteAddr Interface State Rx-int Tx-int Mult Clients
                                 * 2.2.2.2   2.2.2.1    
                                 Po 1      Up    200    200    3     C

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\