Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Configuring Set Conditions

To configure a set condition, use the following commands.

  • Generate a tag to be added to redistributed routes. CONFIG-ROUTE-MAP mode set automatic-tag
  • Specify an OSPF area or ISIS level for redistributed routes. CONFIG-ROUTE-MAP mode set level {backbone | level-1 | level-1-2 | level-2 | stub-area}
  • Specify a value for redistributed routes. CONFIG-ROUTE-MAP mode set metric {+ | - | metric-value}
  • Specify an OSPF or ISIS type for redistributed routes. CONFIG-ROUTE-MAP mode set metric-type {external | internal | type-1 | type-2}
  • Assign an IP address as the route’s next hop. CONFIG-ROUTE-MAP mode set next-hop ip-address
  • Specify a tag for the redistributed routes. CONFIG-ROUTE-MAP mode set tag tag-value

To create route map instances, use these commands. There is no limit to the number of set commands per route map, but the convention is to keep the number of set filters in a route map low. Set commands do not require a corresponding match command.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\