Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

To assign, disable, or reset OSPFv3 globally, use the following commands.

• Enable the OSPFv3 process globally and enter OSPFv3 mode. CONFIGURATION mode ipv6 router ospf { process ID} The range is from 0 to 65535.
• Assign the router ID for this OSPFv3 process. CONF-IPV6-ROUTER-OSPF mode router-id { number}
  • number : the IPv4 address.
  The format is A.B.C.D.
  • NOTE: Enter the router-id for an OSPFv3 router as an IPv4 IP address.
• Disable OSPF. CONFIGURATION mode no ipv6 router ospf process-id
• Reset the OSPFv3 process. EXEC Privilege mode clear ipv6 ospf process