Dell ObjectScale 1.3 Administration Guide

OBJSTEPUPD–4007

Name

PostCheck

Description

Step: PostCheck

Issue Category

Manual

Notifiers

objectscale-snmp-notifier

Remedies

• Run kubectl get deployments -n <objectscale namespace> and verify the Ready replicas are equal to the Total replicas i.e. check the READY status.
• Run kubectl get statefulsets -n <objectscale namespace> and verify the Ready replicas are equal to the Total replicas i.e. check the READY status.
• Verify all the containers of all the replicas are in running state.
• Run kubectl get nodes -A and ensure that the number of nodes in greater than 4.
• Verify if the total number of nodes is less than or equal to 9, then number of ready nodes is greater than or equal to totalNodes-1.
• Verify if the total nodes is greater than 9, then the number of ready nodes is greater than or equal to 4*TotalNodes/5.
• Run kubectl get pods -A grep objectscale-manager-service-pod and verify the pod is in the Running state.
• Run kubectl get ecs -A and verify the Status Phase is Available for all.
• For additional information on this event, go to www.dell.com/support/objectscale and use the SymptomID to search support for the knowledge base article.