Perform these steps to power up the
Storage Center hardware after powering
off the hardware or after a power outage.
About this task
If the
Storage Center hardware includes
expansion enclosures, turn on the
expansion enclosures first, then
turn on the
storage system.
Steps
Connect the
storage system and any
expansion enclosures to a power
source.
Turn on any
expansion enclosures attached to
the
Storage Center.
NOTE: After an
expansion enclosure is
powered on, its ID number is displayed on the back panel. If you want
the
expansion enclosures IDs
to appear in sequential order, turn on each
expansion enclosure one at a time, in
the order that you want the IDs to appear.
Press both power switches on the back of
the
expansion enclosure at the same
time to turn on the
expansion enclosure.
The status indicator on the front of the
expansion enclosure turns blue when the
expansion enclosure is powered up and
operational.
Power on any additional
expansion enclosures attached to
the
Storage Center, waiting for
each
expansion enclosure to become
operational before turning on the next
expansion enclosure.
After all the
expansion enclosures are powered
on, turn on the
storage system by
pressing both power switches on the back of the chassis.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\