Operation of the enclosure with modules missing disrupts the airflow and prevents the enclosure from receiving sufficient cooling.
NOTE For a 2U enclosure, all IOM and PCM slots must be populated. In addition, empty drive slots (bays) in 2U enclosures must hold blank drive carrier modules. For a 5U enclosure, all controller module, IOM, FCM, and PSU slots must be populated.
Follow the instructions in the module bay caution label affixed to the module being replaced.
Replace a defective PCM with a fully operational PCM within 24 hours. Do not remove a defective PCM unless you have a replacement model of the correct type ready for insertion.
Before removal or replacement of a PCM or PSU, disconnect supply power from the module to be replaced. See the
Dell PowerVault ME5 Series Storage System Owner’s Manual.
Follow the instructions in the hazardous voltage warning label attached to the power cooling modules.
CAUTION 5U84 enclosures only
To prevent a rack from tipping over, drawer interlocks stop users from opening both drawers simultaneously. Do not attempt to force open a drawer when the other drawer in the enclosure is already open. In a rack containing more than one 5U84 enclosure, do not open more than one drawer per rack at a time.
Observe the hot surface label that is attached to the drawer. Operating temperatures inside enclosure drawers can reach 60°C (140°F) . Take care when opening drawers and removing DDICs.
Due to product acoustics, ear protection should be worn during prolonged exposure to the product in operation.
Observe the drawer caution label. Do not use open drawers to support any other objects or equipment.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\