The
5U84 enclosure is delivered without the disks installed.
NOTE Due to the weight of the enclosure, install it into the rack without DDICs installed, and remove the back panel CRUs to decrease the enclosure weight.
The adjustment range of the rail kit from the front post to the rear post is 660 mm (26 in.) to 840 mm (33 in.). This range suits a one-meter deep rack within Rack Specification IEC 60297.
Remove the rail kit from the accessories box, and examine for damage.
Ensure that the preassembled rails are the correct length for the rack.
Use the following procedure to install the rail in the rack:
Loosen the position locking screws on the rail.
Identify the rack holes for installing the rails in the rack and insert the rail pins into the rear rack post.
Extend the rail to fit between the front and rear rack posts and insert the rail pins into the front rack post.
NOTE Ensure that the rail pins are fully inserted in the rack holes in the front and rear rack posts.
Use the clamping screws to secure the rail to the rack posts and tighten the position locking screws on the rail.
Ensure the four rear spacer clips (not shown) are fitted to the edge of the rack post.
Figure 1. Install the rail in the rack (left side rail shown for 5U enclosure)
Table 1. Install the rail in the rack
Item
Description
Item
Description
1
Enclosure fastening screws (A)
7
5U84 chassis section shown for reference
2
Left rail
8
Front rack post (square hole)
3
Rear rack post (square hole)
9
Position locking screws
4
Clamping screw (B)
10
5U84 chassis section shown for reference
5
Clamping screw (B)
11
Enclosure fastening screw (C)
6
Rail pins (quantity 4 per rail)
12
Rail kit fasteners used in rackmount installation (A= fastening; B= clamping; C= fastening)
Repeat the previous steps to install the other rail in the rack.
Install the enclosure into the rack:
Lift the enclosure and align it with the installed rack rails.
CAUTION A mechanical lift is required to safely lift the enclosure for positioning in the rack.
Slide the enclosure onto the rails until it is fully seated.
Secure the front and rear of the enclosure using the enclosure fastening screws.
Reinsert the back panel modules and install the DDICs into the drawers. See the instructions in the
Dell PowerVault ME5 Series Storage System Owner’s Manual.
Installing a controller module
Installing an IOM
Installing a fan cooling module
Installing a PSU
Installing a DDIC
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\