Configure a software iSCSI adapter on a XenServer host
Perform the following steps to configure a software iSCSI adapter on a XenServer host:
Steps
-
Log in to XenCenter and select the XenServer host.
-
Select the pool in the
Resources pane, and click the
Networking tab.
-
Identify and document the network name that is used for iSCSI traffic.
-
Click
Configure
The
Configure IP Address dialog box is displayed.
-
Select
Add IP address in the left pane.
-
Type a name for the interface in the
Name field.
-
Select the network identified in step 3 from the
Network drop-down menu.
-
Assign IP addresses to the interface using your planning worksheet.
-
Click
OK.
-
Repeat the previous steps for each network to use for iSCSI traffic.
NOTE If you are using jumbo frames, they must be enabled and configured on all devices in the data path, adapter ports, switches, and storage system.
Data is not available for the Topic