Before beginning the enclosure installation, familiarize yourself with the system configuration requirements.
Table 1. System configuration
Module type
Location
Description
Drive carrier modules
2U front panel
All drive slots must hold either a drive carrier or blank drive carrier module. Empty slots are not allowed. At least one disk must be installed.
DDIC
5U front panel drawers
Maximum 84 disks are installed (42 disks per drawer). Minimum 28 disks are required. Follow the drawer population rules in
Populating drawers with DDICs.
Power cooling modules
2U rear panel
Two PCMs provide full power redundancy, allowing the system to continue to operate while a faulty PCM is replaced.
Power supply unit modules
5U rear panel
Two PSUs provide full power redundancy, allowing the system to continue to operate while a faulty PSU is replaced.
Fan cooling modules
5U rear panel
Five FCMs provide airflow circulation, maintaining all system components below the maximum temperature allowed.
Controller modules and IOMs
Rear panel
One or two controller modules may be installed in 2U12 and 2U24 enclosures.
Two controller modules must be installed in 5U84 enclosures.
Two IOMs must be installed in 2U12, 2U24, and 5U84 enclosures.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\