CAUTION:Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
Steps
Align the slots on the power pass-through
board bracket with the metal standoffs on the chassis, and lower the
board into the chassis.
Grasping the power pass-through board with
the holders, slide the board toward the back of the system until the
connector engages with the midplane.
When firmly seated, the slots on the power
pass-through board bracket get locked with the metal standoffs and
the release pin clicks into the chassis slot.
Reinstall the following:
system board
power distribution board
PCIe cage
hard drive backplane
backplane expander board
cooling fan assembly
cooling shroud
Close the system.
If applicable, place the system upright on
a flat, stable surface and rotate the system feet outward.
Reinstall the following:
hard drives
server modules
power supply units
Reconnect the enclosure to its electrical
outlet and turn the enclosure on, including any attached peripherals.
Turn on the server modules using the operating
system commands or the CMC.
If applicable, install the front bezel.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\