To configure the wireless local area network
settings, use Setup a new connection or network window, if wireless support is allowed on the thin client device.
To configure
the wireless local area network settings, do the following:
Log in as an administrator.
Go to Start > Control Panel > Network and Sharing
Center > Setup a new connection or network. You can also select the Open network, and sharing
session on the taskbar that appears on the Thin Client Administrator
Desktop.
In the Setup a new connection
or network window, select Manually Connect to
Wireless Network.
Click Next.
In the dialog box, enter the following:
Network Name
Security type
Encryption type
Security key
NOTE: Depending on the authentication, enter the security key.
Select the Start this connection automatically check box.
On the taskbar, select the Open network
and sharing session and the name of the network which you entered.
Select Connect.
NOTE:You can also view the network available and directly connect from
the Open network and sharing session on the taskbar of the
Thin Client Administrator Desktop.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\