The following image indicates the location of the solid-state drive and provides a visual representation of the removal procedure.
Steps
Remove the screw (M2x2) that secures the solid-state drive thermal bracket and the solid-state drive 2 to the system board.
Slide the solid-state drive thermal bracket from the peg and lift it from the system board.
Slide and remove the solid-state drive 2 from the solid-state drive slot.
NOTE:The size of the solid-state drive thermal bracket varies based on the storage type. A solid-state drive thermal bracket that is designed for an M.2 2280 drive cannot accommodate an M.2 2230 drive and vice versa. To use a M.2 2230 drive, an M.2 solid-state drive bracket must be used. Follow the procedure in
Removing the M.2 2230 solid-state drive.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\