Removing the right fan
About this task
The following images indicate the location of the right fan and provide a visual representation of the removal procedure.
Steps
- Remove the two screws (M2x4) that secure the I/O-board FPC bracket to the right fan and the palm-rest and keyboard assembly.
- Lift the I/O-board FPC bracket off the system board.
- Remove the screw (M2x4) that secures the fan to the system board.
- Disconnect the right-fan cable from the system board.
- Partially lift the left side of the right fan and slide it to the left to remove it from the palm-rest and keyboard assembly.
CAUTION:Do not hold the fan assembly at the center, as it may damage the center bearing.
CAUTION:When removing the fan, do not lift the fan up directly as this may damage the fan.
NOTE:The images that are shown above are for the right fan, but the same information applies for the left fan.
Data is not available for the Topic