The following images indicate the location of the display assembly cable and display-assembly hinges and provide a visual representation of the removal procedure.
Steps
Loosen the three captive screws that secure the display-assembly cable bracket to the system board.
Lift the display-assembly cable bracket off the system board.
Remove the two screws (M1.6x3) that secure the display-assembly cable holder to the palm-rest and keyboard assembly.
Disconnect the touchscreen cable and camera cable.
Remove the eight screws (M2.5x5.5) that secure the left and right display-assembly hinges to the system board and the palm-rest and keyboard assembly.
Slide the palm-rest and keyboard assembly from the display assembly.
After performing all the above steps, you are left with display assembly.
NOTE:The display assembly is a Hinge-Up Design (HUD) assembly and cannot be further disassembled once it is removed from the bottom chassis. If any components in the display assembly are malfunctioning and need to be replaced, replace the entire display assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\