If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the display-assembly cable and display-assembly hinges and provide a visual representation of the installation procedure.
Steps
Slide the palm-rest and keyboard assembly under the display-assembly hinges.
Align the screw holes on the palm-rest assembly with the screw holes on the right and left display-assembly hinges.
Replace the four screws (M2.5x5.5) that secure the left hinge to the system board and the palm-rest and keyboard assembly.
Replace the four screws (M2.5x5.5) that secure the right hinge to the system board and the palm-rest and keyboard assembly.
Align the screw holes on the display-assembly cable holder with the screw holes on the palm-rest and keyboard assembly.
Connect the touchscreen cable and camera cable to the display-assembly cable .
Replace the two screws (M1.6x3) that secure the display-assembly cable holder to the palm-rest and keyboard assembly.
NOTE:Apply gentle torque when tightening the two screws (M1.6x3) to avoid damaging the screw threads.
Align the screw holes on the display-assembly cable bracket with the screw holes on the system board.
Tighten the three captive screws that secure the display-assembly cable bracket to the system board.