Installation display panel
Steps
- Place the display panel on a flat and clean surface [1].
- Connect the display cable to the connector at the back of the display panel and close the latch to secure the cable [2].
- Adhere the tape that secures the display cable
to the back of the display panel [3].
- Turn the display panel over and place it on the display
back-cover and antenna assembly [4].
- Align the screw holes on the display panel
with the screw holes on the display back-cover and antenna assembly.
- Replace the four (M2x2) screws that secure the display
panel to the display back-cover and antenna assembly [1].
Data is not available for the Topic