Removing the display assembly
Steps
- Open the latch and disconnect the optical drive cable and display cable from the system board [1, 2].
- Peel off the tape securing the wireless antenna from the system board [3].
- Unroute the display cable from the routing guides on the palmrest and keyboard assembly [4].
- Remove the
five (M2.5x5) screws that secure the left and right hinges to the system board, and palmrest and keyboard assembly [1].
- Lift the palmrest and keyboard assembly at an angle [2].
- Lift the hinges and remove the palmrest and keyboard assembly off the display assembly [1, 2].
- After performing all the preceding steps, you are left with display assembly.
Data is not available for the Topic