Open the latch and disconnect the I/O board cable
from the system board [2].
Remove the single (M2x4) screw that secures the I/O board to the palm rest
and keyboard assembly [1].
Lift the I/O board, along with the cable, off the palm rest and keyboard assembly [2].
NOTE: : When the IO board cable is disconnected from the system board,
an RTC error occurs. This error occurs whenever the RTC/coin-cell
battery, IO board, or system board are removed.
In such instances, after the system is reassembled, it will
undergo and RTC reset cycle and the computer turns on and turn off
several times.
An "Invalid Configuration" error message is displayed prompting
you to enter the BIOS and configure the date and time. The computer
starts functioning normally after setting the date and time.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\