Disconnect the display cable from the connector on the system board.
Unthread the display cable and WLAN antenna cables from the routing channels.
Open the system to at least 90-degrees and place the system on the edge of a table so that the palm rest is laying flat on the table and the display assembly is over the edge.
Remove the six (M2.5x6) screws securing the display assembly in place.
Remove the display assembly from the system.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\