If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the power-button with optional fingerprint reader and provides a visual representation of the installation procedure.
Steps
Using the alignment posts, place the power-button into its slot on the palm-rest and keyboard assembly.
Replace the two screws (M2x2) that secure the power-button to the palm-rest and keyboard assembly.
Connect the power-button cable to the fingerprint-reader board and close the latch, if applicable.
Adhere the tape that secures the power-button cable to the palm-rest and keyboard assembly, if applicable.