Removing the M.2 2230 solid-state drive
About this task
NOTE This procedure applies only to computers shipped with an M.2 2230 solid-state drive installed.
NOTE The M.2 card installed on your computer will depend on the configuration ordered. Supported card configurations on the M.2 card slot:
- M.2 2230 solid-state drive + 2230 mounting bracket
- M.2 2280 solid-state drive
The following images indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the removal procedure.
Steps
- Loosen the single captive screw and remove the single (M2x2.2) screw that secures SSD thermal plate to the palmrest, to lift it out of the system.
- Slide and remove the M.2 2230 mounting bracket off the system board.
- Turn the thermal plate over and remove the single (M2x2) screw securing the M.2 2230 SSD to the thermal plate.
- Slide and remove the M.2 2230 solid-state drive off the mounting bracket.
Data is not available for the Topic