Installing the IO board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the I/O board and provides a visual representation of the installation procedure.
Steps
- Place the I/O board on the palm-rest and keyboard assembly.
- Align the screw holes on the I/O board to the screw holes on the palm-rest and keyboard assembly.
- Replace the four screws (M2x4) that secure the I/O board to the palm-rest and keyboard assembly.
- Connect the fingerprint-reader board cable to the connector on the I/O board and close the latch, if applicable.
- Connect the I/O-board power cable to the connector on the I/O board and close the latch.
- Connect the fingerprint-reader cable to the connector on the I/O board and close the latch, if applicable.
- Connect the I/O-board cable to the connector on the I/O board and close the latch.
Data is not available for the Topic