Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the display assembly and provides a visual representation of the installation procedure.
![Installing the display assembly](https://dl.dell.com/topics/vostro_3405_sm/images/GUID-222CA184-7BD6-4EA5-A824-29A288E198F4-low.jpg)
![Installing the display assembly](https://dl.dell.com/topics/vostro_3405_sm/images/GUID-167443B1-9F41-4E91-B212-C65BC1DAE5E2-low.jpg)
Steps
- Place the display assembly on the palm-rest and keyboard assembly.
- Align the screw holes on the display hinges with the screw holes on the palm-rest and keyboard assembly.
- Replace the 6 screws (M2.5x5) that secure the display hinges to the palm-rest and keyboard assembly.
- Route the display cable through the routing guides on the palm-rest and keyboard assembly.
- Connect the display cable to the connector on the system board.
Data is not available for the Topic