Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Vostro 3405 Service Manual

PDF

Installing the base cover

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the base cover and provides a visual representation of the installation procedure.

Installing the base cover

Installing the base cover

Installing the base cover

Steps

  1. Connect the battery cable to the connector on the system board.
  2. Place and snap the base cover into place on the palm-rest and keyboard assembly.
  3. Tighten the two captive screws on the base cover.
  4. Replace the seven screws (M2.5x5) that secure the base cover to the palm-rest and keyboard assembly.

Next steps

  1. Install the SD card.
  2. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\