Installing the display panel
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the display panel and provides a visual representation of the installation procedure.
![Installing the display panel](https://dl.dell.com/topics/vostro_3405_sm/images/GUID-3DA88398-331F-47B2-A725-C457436DE7CB-low.jpg)
![Installing the display panel](https://dl.dell.com/topics/vostro_3405_sm/images/GUID-A20611F4-099D-46C6-9DC4-1568635DDBF9-low.jpg)
![Installing the display panel](https://dl.dell.com/topics/vostro_3405_sm/images/GUID-675ECB56-5DF8-4AC0-A3EC-70A78E89E25E-low.jpg)
Steps
- Place the display panel and display assembly on a clean and flat surface.
- Connect the display cable to the connector on the display panel and close the latch.
- Adhere the tape that secures the display-cable connector latch to the display panel.
- Lift and rotate the display panel, then place the display panel on the display assembly.
- Align the screw holes on the display panel to the screw holes on the display assembly.
- Replace the six screws (M2.5x2.5) that secure the display panel to the display assembly.
- Place the display bezel on the display assembly.
- Align the tabs on the display bezel to the slots on the display assembly.
- Press down on the display bezel and snap the display bezel in place.
Data is not available for the Topic