Installing the M.2 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE This procedure applies if you are installing a M.2 2230 solid-state drive.
NOTE The M.2 card installed on your computer will depend on the configuration ordered. Supported card configurations on the M.2 card slot:
- M.2 2230 solid-state drive + 2230 mounting bracket
- M.2 2280 solid-state drive
The following images indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the installation procedure.
![Installing the M.2 2230 solid-state drive](https://dl.dell.com/topics/vostro_3405_sm/images/GUID-556B6644-1028-4EE5-B652-0A36E0279952-low.jpg)
Steps
- Place the solid-state drive into the thermal plate and install the single (M2x2) screw.
- Align the notch on the M.2 2230 solid-state drive with the tab on the M.2 card slot on the system board.
- Slide the M.2 2230 solid-state drive into the M.2 card slot on the system board.
- Replace the single (M2x2.2) screw and tighten the single captive screw to secures the thermal plate to the palmrest.
Data is not available for the Topic