Removing the system board - Cirrus Logic audio
About this task
Steps
- Disconnect the following cables from the system board:
- Speaker cable
- Keyboard FFC
- Power adapter port cable
- Keyboard backlight FFC
- Touchpad FFC
- Hard drive FFC
- IO board FFC
- Fingerprint reader FFC
- Power button FFC from the system board
- Peel back the Mylar tape from over the screw hole
- Remove the two (M2x4) screws that secures the system board to the palmrest.
- Carefully lift the system board away from the chassis.
Data is not available for the Topic