Installing the system board - Cirrus Logic audio
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
Steps
- Align and place the system board on the palmrest.
- Peel back the Mylar tape from over the screw hole.
- Replace the two (M2x4) screws that secures the system board to the palmrest.
- Connect the following cables to the system board:
- Speaker cable
- Keyboard FFC
- Keyboard backlight FFC
- Touchpad FFC
- Hard drive FFC
- IO board FFC
- Power adapter port cable
- Fingerprint reader FFC
- Power button FFC from the system board
- Fold back the right hinge and install the two (M2.5x5) screws to secure it to the palmrest.
Data is not available for the Topic