Installation display panel
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
![Installation display panel](https://dl.dell.com/topics/vostro_3400_sm/images/GUID-0D4DC2D4-F326-4138-8921-AA1C382AE73D-low.jpg)
![Installation display panel](https://dl.dell.com/topics/vostro_3400_sm/images/GUID-A000204E-A951-496E-B3ED-467F0982988F-low.jpg)
Steps
- Place the display panel on a flat and clean surface .
- Connect the display cable to the connector at the back of the display panel and close the latch to secure the cable .
- Adhere the tape that secures the display cable to the back of the display panel .
- Turn the display panel over and place it on the display back-cover .
- Replace the six (M2.5x2.5) screws that secure the display panel to the display back-cover.
Data is not available for the Topic