Ensure that
Success status is displayed for the device.
About this task
Dell technical support engineers may need to access your device to troubleshoot the device or perform any device-specific actions. So, you can enable remote access for the device, if necessary. You can also disable remote access to the device after the remote session is complete.
NOTE:You can manually enable or disable remote access only for PowerEdge servers and PowerSwitch switches from the
secure connect gateway user interface.
Steps
On the
Devices page, click
beside the device IP address or hostname, and click
Enable remote access.
NOTE:If
Failed status is displayed for the device, the
Enable remote access option is disabled.
Click
Yes to confirm that you want to enable remote access for the device.
Remote access is enabled for the device.
After the remote session is complete, click
beside the device IP address or hostname, click
Disable remote access, and then click
Yes to confirm.
Remote access is disabled for the device.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\