Add a converged or hyperconverged infrastructure appliance
Prerequisites
Ensure that the device model can be added from
secure connect gateway user interface. For information about the device models that can be added, see
Methods of adding devices.
Steps
Go to
Device management > Manage devices > Devices > Add device.
From the
Device type list, select
Converged/Hyper-Converged Infrastructure.
If you selected any other model, perform the following steps. For information about the other hyperconverged infrastructure appliance models that can be added from
secure connect gateway, see
Methods of adding devices.
Enter the IP address and serial number of the device.
Select the device extension.
Click
Next.
The device is discovered, and then the
Devices page is displayed with the device details.
NOTE:You cannot use other features in
secure connect gateway during the device discovery process.
NOTE:To enable remote support and remote actions capabilities for these models, configure the settings using Policy Manager or contact Dell technical support.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\