Removing the
display assembly
- Follow the procedure in Before working inside
your computer.
- Remove the:
- battery cover
- battery
- base cover
- hard drive
- keyboard
- WLAN card
- WWAN card
- palmrest
- Perform the following as shown in the illustration:
- Remove the screws that secure the display
hinge cap to the computer [1].
- Remove the display hinge cap from the computer
[2].
- Perform the following steps as shown in the
illustration:
- Flip the computer and remove the cosmetic
screws from the bottom and back of the computer [1].
- Pull up the antenna cables through the
routing hole [2].
- Perform the following as shown in the illustration:
- Remove the screw that secures the eDP cable bracket
[1].
- Remove the eDP cable bracket [2].
- Peel off the tape on the heat pipe and disconnect
the eDP cable from the system board [3, 4].
- Remove the screws that secure the display
assembly to the computer and remove it from the computer [5, 6].
Data is not available for the Topic