Disconnect the intrusion switch cable [1], USB 3.1 cable [2], front I/O power cable [3], USB 3.1 cable [4], Speaker cable [5], Audio cable [6]
NOTE:Do not pull the connector by the cable wires.
Instead, disconnect the cable by pulling the connector end.
Pulling the cable wires may loosen them from the
connector.
Remove the screw[1] that secures the front I/O panel to the chassis and slide the I/O panel out of the chassis[2].
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\