If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the 3.5-inch hard-disk drive assembly and provides a visual representation of the installation procedure.
Steps
Press the release tabs on the hard-disk drive bracket and align to insert the hard-disk drive assembly to the slot on the computer chassis.
Connect the hard drive data and power cables to the connectors on the 3.5-inch hard-disk drive module.
Route the hard drive data and power cables through the routing hook.
Insert the tab on the PCIe card holder into the slot on the chassis and gently press down until it is secured to the graphics card.