Hold the system board by its edges, and align it towards the back
of the system.
Lower the system board into the system chassis until the connectors at
the back of the system board align with the slots on the chassis,
and the screw holes on the system board align with the standoffs on
the system chassis [1,2].
Replace the
5 screws that secure the system
board to the system [1], the single (M3x5) screw [2], and the single (#6-32) screw [3].
Align the cables with the pins on connectors on the system board
and connect intrusion switch cable [1], PSU power cable [2], data cable [3], system fan cable [4], SATA cable [5], SATA power cable [6] to the system board:
Insert the hook on the I/O panel into the slot on the chassis and rotate to close the I/O panel [1].
Replace the screw to secure the I/O panel to the chassis [2].
Connect the
power switch cable [3], route the power cable through the retention clips on the chassis [4], psu cable [5] and, intrusion switch cable [6] from the connectors on the system board.