Installing the
hard drive and optical drive module
Steps
- Insert the tabs on the hard drive and optical drive module into the slot on the
system at a 30 degree angle [1].
- Connect the optical drive data cable and power cable to the connectors
on the optical drive [2, 3].
- Lower the hard drive and optical drive module so that it is placed in its slot [4].
- Route the optical drive data cable and power cable through the
retention clips [1].
- Route the hard drive data and power cables through the
HDD-ODD release tab
[2].
- Slide the release tab to lock the module [1].
- Connect the hard drive data cable and power cable from the connectors
on the hard drive [2, 3].
- Install the:
- Front bezel
- Side cover
- Follow the procedure in After working inside your computer.
Data is not available for the Topic