Installing the
power supply unit or PSU
Steps
- Insert the PSU in the chassis and slide it towards the back of the
system to secure it [1].
- Replace the screws to secure the PSU to the rear chassis of the system
.
- Connect the
power cable to the connector on the system board [1].
- Route the system
power cable through the retention clips [2].
- Route the CPU
power cable through the retention clips [3].
- Connect the CPU power cable to the connector on the system board [4].
- Install the:
- Hard drive and optical drive module
- Front bezel
- Side cover
- Follow the procedure in After working inside your computer.
Data is not available for the Topic