Allows you to enable or disable the computer from
turning on automatically when an AC adapter is connected.
Default setting: Wake on AC is not selected.
Auto On Time
Allows you to set the time at which the computer must
turn on automatically. The options are:
Disabled
Every Day
Weekdays
Select Days
Default setting: Disabled
Deep Sleep Control
Disabled (selected by default)
Enabled in S5 only
Enabled in S4 and S5
USB Wake Support
Allows you to enable USB devices to wake the system
from Standby.
NOTE This feature is only functional when the AC power adapter is connected.
If the AC power adapter is removed during Standby, the system setup
removes power from all the USB ports to conserve battery power.
Enable USB Wake Support
Wake on Dell USB-C dock
Wireless Radio Control
Allows you to enable or disable the feature that automatically
switches from wired or wireless networks without depending on the
physical connection.
Control WLAN Radio
Control WWAN Radio
Wake on LAN/WLAN
Allows you to enable or disable the feature that powers
on the computer from the Off state when triggered by a LAN signal.
Disabled
LAN Only
WLAN Only
LAN or WLAN
Default setting: Disabled
Peak Shift
This option enables you to minimize the AC power consumption
during the peak power times of day. After you enable this option,
your system runs only in battery even if the AC is attached.
Enable peak shift (disabled)
Set battery threshold
Advanced Battery Charge Configuration
This option enables you to maximize the battery health.
By enabling this option, your system uses the standard charging algorithm
and other techniques, during the non-work hours to improve the battery
health.
Primary Battery Charge Configuration
Allows you to select the charging mode for the battery.
The options are:
Adaptive (default)
Standard — Fully charges your battery at a standard
rate.
ExpressCharge — The battery charges over a shorter
period of time using Dell’s fast charging technology. This option
is enabled by default.
Primarily AC use
Custom
If Custom Charge is selected, you can also configure Custom Charge
Start and Custom Charge Stop.
NOTE All charging mode may
not be available for all the batteries. To enable this option, disable
the Advanced Battery Charge Configuration option.
Type-C connector power
7.5 Watts(selected by default)
15 Watts
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\