Installing the
display assembly
- Insert the display assembly
into the slots on the computer.
- Replace the M2.0X3 screws to secure the display
assembly in place.
- Affix the tape on the heat sink.
- Connect the eDP cable to the connectors
on the system board.
- Insert the wireless antenna cables through
the routing hole on the chassis.
- Replace the display assembly M2.0X3 screws
at the bottom and back of the computer.
- Align the display hinge cap and tighten the
M2.5x4.0 screws to secure it to the computer.
- Connect the antenna cables to the
connectors.
- Install the:
- palmrest
- WWAN card
- WLAN card
- keyboard
- hard drive
- base cover
- battery
- battery cover
- Follow the procedure in After working inside
your computer.
Data is not available for the Topic