Removing the
display assembly
- Follow the procedure in Before working inside
your computer.
- Remove the:
- battery cover
- battery
- base cover
- hard drive
- keyboard
- WLAN card
- WWAN card
- palmrest
- To remove hinge cap:
- Remove the M2.5x4.0 screws that secure
the hinge caps [1].
- Remove the hinge caps from the computer
[2].
- To disconnect antenna cables:
- Flip the computer and remove the M2.0X3
screws from the computer [1].
- Pull the antenna cables through the
routing hole [2].
- To remove display assembly:
- Flip the computer and open the display.
- Remove the M2.0X3 screw that secures the eDP cable bracket
[1].
- Remove the eDP cable bracket [2].
- Peel off the tape on the heat sink and disconnect
the eDP cable from the system board [3].
- Remove the M2.0X3 screws that secure the
display assembly to the computer and remove it from the computer [4].
Data is not available for the Topic