If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the system board and provides a visual representation of the installation procedure.
Steps
Locate the system board slot on your computer.
Slide the ports on the system board into the slots on the palm-rest and keyboard assembly and align the screw holes on the system board with the screw holes on the palm-rest and keyboard assembly.
Install the four (M2x3) screws that secure the system board to the palm-rest and keyboard assembly.
Align and place the fingerprint reader sensor on to the slot on the computer.
Place the finger print reader metal bracket over the finger print sensor.
Replace the single (M2x3) screw to secure the metal bracket to the computer.
Connect the display cable on to the connector on the system board.
Adhere the tape that secures the display board to the system board.
Install the two screws (M2x3) that secure the EDP metal bracket to the system board.
Connect the keyboard cable to the system board and close the latch to secure the cable.
Connect the touchpad cable to the system board and close the latch to secure the cable.