- Notes, cautions, and warnings
- About this document
- Dell PowerEdge XE9680 system configurations and features
- Technical specifications
- Chassis dimensions
- System weight
- Processor specifications
- PSU specifications
- Cooling fan specifications
- Supported operating systems
- System battery specifications
- Expansion card riser specifications
- Memory specifications
- Storage controller specifications
- Drives
- GPU Specifications
- Ports and connectors specifications
- Video specifications
- Environmental specifications
- Initial system setup and configuration
- Pre-operating system management applications
- System Setup
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Front top cover
- Cooling fans
- Air shroud
- Side wall brackets
- Drives
- Removing a drive blank
- Installing a drive blank
- Removing a drive carrier
- Installing the drive carrier
- Removing the drive from the drive carrier
- Installing the drive into the drive carrier
- Removing an EDSFF E3.S drive blank
- Installing an EDSFF E3.S drive blank
- Removing an EDSFF E3.S drive carrier
- Installing an EDSFF E3.S drive carrier
- Removing an EDSFF E3.S drive from the drive carrier
- Installing an EDSFF E3.S drive into the drive carrier
- Drive backplane
- Drive cage
- PERC module
- Cable routing
- Expansion cards and expansion card risers
- Expansion card installation guidelines
- Removing the PSB top cover
- Installing the PSB top cover
- Removing the PCIe Switch Board module
- Installing the PCIe Switch Board module
- Removing expansion card from the PCIe Switch Board module
- Installing an expansion card into the PCIe Switch Board module
- Removing expansion card from the NIC slots on PCIe Base Board module
- Installing an expansion card into the NIC slots on PCIe Base Board module
- Removing the PCIe Base Board
- Installing the PCIe Base Board
- SmartNIC/DPU card
- Power supply unit
- Power distribution board
- PSU cage
- Power interposer board
- Intrusion switch
- Optional BOSS-N1 module
- System memory
- Processor and heat sink module
- GPU fans and cage
- GPU tray
- System battery
- Trusted Platform Module
- System board
- Optional OCP NIC card
- LOM card, MIC card, and rear I/O board
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Using system diagnostics
- Getting help
- Documentation resources
Dell PowerEdge XE9680 Installation and Service Manual
About this document
This document provides an overview about the system, information about installing and replacing components, diagnostic tools, and guidelines to be followed while installing certain components.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\