- Notes, Cautions, and Warnings
- Working on Your Computer
- Removing and
Installing Components
- Recommended Tools
- Removing the Cover
- Installing the Cover
- Removing the Intrusion Switch
- Installing the Intrusion Switch
- Removing the Wireless Local Area Network (WLAN) Card
- Installing the Wireless Local Area Network (WLAN) Card
- Removing the Front Bezel
- Installing the Front Bezel
- Removing the Expansion Card
- Installing the Expansion Card
- Memory Module Guidelines
- Removing the Memory
- Installing the Memory
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Optical Drive
- Installing the Optical Drive
- Removing the Speaker
- Installing the Speaker
- Removing the Power Supply
- Installing the Power Supply
- Removing the Heat Sink Assembly
- Installing the Heat Sink Assembly
- Removing the Processor
- Installing the Processor
- Removing the System Fan
- Installing the System Fan
- Removing the Thermal Sensor
- Installing the Thermal Sensor
- Removing the Power Switch
- Installing the Power Switch
- Removing the Input/Output (I/O) Panel
- Installing the Input/Output (I/O) Panel
- Removing the System Board
- Installing the System Board
- System Board Components
- System Setup
- Diagnostics
- Troubleshooting Your Computer
- Specifications
- Contacting Dell
Dell OptiPlex 9020 Mini Tower Owner's Manual
Installing the System Board
- Align the system board to the port connectors on the rear of the chassis and place the system board in the chassis.
- Tighten the screws securing the system board to the chassis.
- Connect the cables to the system board.
-
Install the:
- processor
- heat-sink assembly
- expansion card(s)
- memory
- cover
- Follow the procedures in After Working Inside Your Computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\