If you enable UEFI network stack,
UEFI network protocols will be available. UEFI network allows pre-os
and early os networking features to use NICs that are enabled. This
may be used without PXE turned on. When you enable Enabled w/PXE,
the type of PXE boot (Legacy PXE or UEFI PXE) depends on the current
boot mode and type of option ROMs in use. The UEFI Network Stack is
required in order to have UEFI PXE functionality fully enabled.
Enabled UEFI Network Stack - This option is disabled
by default.
Allows you to configure the integrated network controller. The
options are:
Disabled
Enabled
Enabled w/PXE: This option is enabled by default.
NOTE: Depending
on the computer and its installed devices, the items listed in this
section may or may not appear.
SATA Operation
Allows you to configure the internal SATA hard-drive
controller. The options are:
Disabled
AHCI: This option is enabled by default.
Drives
Allows you to configure the SATA drives on board.
All drives are enabled by default. The options are:
SATA-0
SATA-1
SATA-2
SATA-3
SATA-4
SMART Reporting
This field controls whether hard drive errors for
integrated drives are reported during system startup. This technology
is part of the SMART (Self Monitoring Analysis and Reporting Technology)
specification. This option is disabled by default.
Enable SMART Reporting
USB Configuration
This field configures the integrated USB controller.
If Boot Support is enabled, the system is allowed to boot any type
of USB Mass Storage Devices (HDD, memory key, floppy).
If USB port is enabled, device attached to this port is enabled and
available for OS.
If USB port is disabled, the
OS cannot see any device attached to this port.
The options are:
Enable Boot Support
Enable Rear USB Ports: Include options for 6 ports
Enable Front USB Ports: Include options for 2 ports
All the options are enabled by default.
NOTE: USB keyboard and mouse
always work in the BIOS setup irrespective of these settings.
Side USB Configuration
This field allows you to enable or disable side USB
ports.
Side Port1 (Top)
Side Port2 (Bottom)
Rear USB Configuration
This field allows you to enable or disable rear USB
ports.
Rear Port (Rear Right)
Rear Port 2 (Front Right)
Rear Port 3 (Rear Left) (Rear Port 4 (Front Left))
Audio
This field enables or disables the integrated audio
controller. By default, the Enable Audio option is selected.
The options are:
Enable Microphone (by default enable)
Enable Internal Speaker (by default enable)
OSD Button Management
This field allows you to enable or disable the
OSD (On-Screen Display) buttons on the All-In-One system.
This
option is disabled by default.
Touchscreen
This option allows you to enable or disable touchscreen.
Miscellaneous Devices
Allows you to enable or disable the following devices:
Enable PCI Slot (enabled by default)
Enable Secure Digital (SD) card (enabled by default)
Secure Digital (SD) Card Boot
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\