Removing the intrusion
switch
- Follow the procedure in Before working inside
your computer.
- Remove the:
- stand
- back cover
- cable cover
- speaker cover
- system board shield
- power supply unit
- VESA mount bracket
- To
remove the intrusion switch:
- Disconnect the intrusion switch cable from
the connector on the system board [1].
- Unthread the intrusion switch cable from
the retention clips on the computer [2].
- Remove the screw that secures the intrusion
switch to the computer [3].
- Slide and lift the intrusion switch away
from the computer [4].
- Perform
the following instructions as shown in the illustration:
- Remove the screw that secures the intrusion
switch to the chassis [1].
- Slide and lift the intrusion switch to
remove it from the computer [2].
Data is not available for the Topic