Allows you to set, change, or delete the administrator
(admin) password.
NOTE: You must set the admin password before you set the system or hard
drive password. Deleting the admin password automatically deletes
the system password and the hard drive password.
NOTE: Successful password
changes take effect immediately.
Default setting:
Not set
System Password
Allows you to set, change or delete the system password.
NOTE: Successful password
changes take effect immediately.
Default setting:
Not set
Strong Password
Allows you to enforce the option to always set strong
passwords.
Default Setting: Enable Strong Password
is not selected.
NOTE: If Strong Password
is enabled, Admin and System passwords must contain at least one uppercase
character, one lowercase character and be at least 8 characters long.
Password Configuration
Allows you to determine the minimum and maximum length
of Administrator and System passwords.
Password Bypass
Allows you to enable or disable the permission to
bypass the System and the Internal HDD password, when they are set.
The options are:
Disabled
Reboot bypass
Default setting: Disabled
Password Change
Allows you to enable the disable permission to the
System and Hard Drive passwords when the admin password is set.
Default setting: Allow Non-Admin Password Changes is selected.
UEFI Capsule Firmware Updates
This option controls whether the system allows BIOS
updates through UEFI capsule update packages.
NOTE: Disabling this option
will block the BIOS updates from services such as Microsoft Windows
Update and Linux Vendor Firmware Service (LVFS).
This option
is enabled by default.
TPM 2.0 Security
Allows you to enable the Trusted Platform Module (TPM)
during POST. This option is enabled by default. The options are:
TPM On
Clear
PPI Bypass for Enabled Commands
PPI Bypass for Disabled Commands
NOTE: Activation,
deactivation, and clear options are not affected if you load the setup
program's default values. Changes to this option take effect immediately.
Computrace
Allows you to activate or disable the optional Computrace
software The options are:
Deactivate
Disable
Activate
NOTE: The Activate
and Disable options will permanently activate or disable the feature
and no further changes will be allowed
Default
setting: Deactivate
Chassis Intrusion
This field controls the chassis intrusion feature.
The options are:
Enabled
Disabled
On-slient
Default Setting: Disabled
OROM Keyboard Access
Allows you to set an option to enter the Option
ROM Configuration screens using hotkeys during boot. The options are:
Enabled
One Time Enable
Disabled
Default Setting: Enabled
Admin Setup Lockout
Allows you to enable or disable the option to enter
setup when an admin password is set.
Enable Admin Setup Lockout - This option is disabled
by default.
Master Password Lockout
If enabled, this option disables the master password
support. The Hard Disk passwords need to be cleared before the setting
can be changed. Default setting: Disabled
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\