Invoke diagnostics boot by either of the methods that are suggested below:
Power on the computer.
As the computer boots, press the F12 key when the Dell
logo is displayed.
In the boot menu screen, use Up/Down arrow key to select the Diagnostics option and then press Enter.
NOTE: The Enhanced Pre-boot System
Assessment window displays, listing all devices detected
in the computer. The diagnostics starts running the tests on all the
detected devices.
Press the arrow in the lower-right corner to go to the page listing.
The detected items are listed and tested.
To run a diagnostic test on a specific
device, press Esc and click Yes to stop the
diagnostic test.
Select the device from the left pane and click Run Tests.
If there are any issues, error codes are displayed.
Note the error code and contact Dell.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\