Unthread the power supply cables from the
retention clips in the chassis [1].
Disconnect the power supply cable from
the connector on the system board [2].
NOTE: Press lock clip to release the power supply cable from the system board.
To release the PSU:
NOTE: There is an additional cable retention clip on the side of the VESA mount bracket. The PSU near that is not visible in the removing cables from retention clips image.
Remove the screw that secures the power
supply socket to the chassis [1].
Slide the socket to remove it from the
computer [2].
To remove the PSU:
NOTE: Field Engineers to ensure defective Power Supply Unit is returned along with BIST board.
Remove the screw that secures the PSU to
the chassis [1].
Slide the PSU and lift it away from the
chassis [2].
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\