Specifies how the computer will respond when AC power
is applied after an AC power loss. You can set the AC Recovery to:
Power Off (default)
Power On
Last Power State
Auto On Time
Allows you to set the time at which the computer must
turn on automatically. The options are:
Disabled
Every Day
Weekdays
Select Days
Default setting: Disabled
NOTE: This feature does not
work if you turn off your computer using the switch on a power strip
or surge protector or if Auto Power is set to disabled.
Deep Sleep Control
Allows you to define the controls when Deep Sleep
is enabled.
Disabled
Enabled in S5 only
Enabled in S4 and S5 – This option is enabled by default.
USB Wake Support
Allows you to enable USB devices to wake the system
from Standby.
NOTE: This feature is only functional when the AC power adapter is connected.
If the AC power adapter is removed during Standby, the system setup
removes power from all the USB ports to conserve battery power.
Enable USB Wake Support
Default setting: The option is disabled.
Wake on LAN/WLAN
Allows you to enable or disable the feature that powers
on the computer from the Off state when triggered by a LAN signal.
Disabled
LAN Only
WLAN Only
LAN or WLAN
LAN with PXE Boot
Default setting: Disabled
Block Sleep
This option lets you block entering to sleep (S3 state)
in operating system environment.
Block Sleep (S3 state)
Default setting: This option is disabled
Intel Ready Mode
This option enables the capability of Intel Ready
Mode technology.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\