Allows you to set, change, or delete the administrator
(admin) password.
NOTE You must set the admin password before you set the system or hard
drive password. Deleting the admin password automatically deletes
the system password and the hard drive password.
NOTE Successful password
changes take effect immediately.
Default setting:
Not set
System Password
Allows you to set, change or delete the system password.
NOTE Successful password
changes take effect immediately.
Default setting:
Not set
Internal HDD-0 Password
Allows you to set, change or delete the system’s internal
hard disk’s password.
Default setting: Not set
NOTE Successful
password changes take effect immediately.
Strong Password
Allows you to enforce the option to always set strong
passwords.
Default Setting: Enable Strong Password
is not selected.
NOTE If Strong Password
is enabled, Admin and System passwords must contain at least one uppercase
character, one lowercase character and be at least 8 characters long.
Password Configuration
Allows you to determine the minimum and maximum length
of Administrator and System passwords.
Password Bypass
Allows you to enable or disable the permission to
bypass the System and the Internal HDD password, when they are set.
The options are:
Disabled
Reboot bypass
Default setting: Disabled
Password Change
Allows you to enable the disable permission to the
System and Hard Drive passwords when the admin password is set.
Default setting: Allow Non-Admin Password Changes is selected.
TPM 1.2 Security
Allows you to enable the Trusted Platform Module (TPM)
during POST. This option is enabled by default. The options are:
Clear
PPI Bypass for Enabled Commands
PPI Bypass for Disabled Commands
Attestation Enable
Key Storage Enable
SHA - 256
NOTE Activation, deactivation, and clear options are not affected
if you load the setup program's default values. Changes to this option
take effect immediately.
Computrace (R)
Allows you to activate or disable the optional Computrace
software The options are:
Deactivate
Disable
Activate
NOTE The Activate
and Disable options will permanently activate or disable the feature
and no further changes will be allowed
Default
setting: Deactivate
Chassis Intrusion
This field controls the chassis intrusion feature.
The options are:
Disabled
Enabled
Default setting: Disabled
CPU XD Support
Allows you to enable or disable the Execute Disable
mode of the processor.
Enable CPU XD Support (default)
OROM Keyboard Access
Allows you to set an option to enter the Option ROM
Configuration screens using hotkeys during boot. The options are:
Enabled
One Time Enable
Disabled
Default setting: Enable
Admin Setup Lockout
Allows you to enable or disable the option to enter
setup when an admin password is set.
Enable Admin Setup Lockout - This option is disabled by default.
HDD Protection Support
Allows you to enable or disable the HDD Protection
feature.
HDD Protection Support - This option is disabled by default.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\